Biomasserister
Chain furnace is a kind of layer burning furnace with a high degree of mechanization, which has the characteristics of simple operation management and easy to master, and is widely used in various industries.
- produkt introduksjon

1. Prevent the slag and ash accumulation on the heating surface, and increase the thermal resistance of the heating area.
During operation, the wind force should be adjusted reasonably to prevent the local temperature in the furnace, and the reasonable flame front position should be located in the middle area of the high-end grate and the central grate, which can effectively reduce the problem of slagging on the heating surface.
2. Install appropriate economizer and air preheater to improve the thermal efficiency of the boiler.
3. Avoid excessive air coefficient.
The amount of flue gas generated by the chain furnace combustion mainly depends on the excess air coefficient in the furnace and the air leakage volume of the boiler. Boiler installation and maintenance quality is high, which can reduce the air leakage volume. The excess air coefficient used in the general biomass chain furnace is 1.3- -1.4. Under the conditions of normal combustion, the excess air sent into the boiler should be reduced as far as possible. Excessive air coefficient is not conducive to chain furnace combustion, but also increases the amount of smoke exhaust and reduces the boiler efficiency.
1. Choose reasonable biomass pellet fuel. The particle fuel with length less than 4 times of diameter, 10% water content, 6% ash content and calorific value 14.6MJ/kg can better ensure sufficient combustion to improve the thermal efficiency of the chain furnace.
2. Reasonable air distribution conditions to ensure full fuel combustion.
3. Combined with the actual combustion condition of the furnace, the feeding speed and feeding amount of the feeder are reasonably set to ensure the combustion time. Avoid the fuel layer is too thick, gas and pellet fuel can not meet the benign mixing, heat storage capacity can not meet the requirements of full combustion.
Populære tags:
Du kommer kanskje også til å like












